Contemporary Metal Wall Art Sculpture Stainless Textured 9T, Atlanta Georgia

Lawrenceville, Georgia

404-375-5238

Contemporary Stainless Steel Metal Wall Art Sculpture 9T

This is an original hand formed metal wall sculpture that was designed and built by me, Richard Walker. I put an enormous amount of time and effort into these pieces to make sure that they are the finest sculptures that are available anywhere. Each piece is completely hand cut and precision welded. As you can see, they are three dimensional. These sculptures stand off of the wall and are designed to allow light to pass through them. Another thing you will notice is the finish. Only the highest quality paints are used. When you take a close look at these pieces you can see how all the time, effort, and high quality materials make these pieces stand apart from all the rest.

Feel free to let me know if you have any questions.

Thanks!

Richard

Dimensions

33 Inches Wide 16 inches Tall by 1.75 inches deep

Stainless Steel Construction

100% Stainless Steel, Precisely Hand Cut and Expertly Welded. Extremely sturdy construction.

Sculpture Colors

Textured black, light blue, and off white.

Paint Details

Textured Finish

Wall Mounting -- Indoors

This sculpture comes ready to hang. Sculptures are designed to be mounted Indoors. Mounting hardware is included! All you need is a Hammer to hang these on your wall!

Original Design

These sculptures are designed, built, and painted by me, Richard Walker. All pieces are signed and dated.

Options

This piece can be custom built in larger sizes. Many more colors are also available. Please see my Color Selection Page. --Additional charges apply--

Purchase

33" x 16" x 1.75"	40" x 20" x 1.75"	48" x 24" x 1.75"
$340 + 24s/h	$499 + 40s/h	$749 + 50s/h

Galleries: Large Pieces, Metallic Blue Designs, Metallic Red Designs, Mountain Landscapes, Silver Designs, Gloss Black Designs, Lighted Designs, Textured Finish Pieces, Freeform Designs, Table Top Pieces, Round Bar Designs, Drawing Gallery, Mosaic Gallery

This piece is actually comprised of 2 pieces, each measuring 16.5" wide by 16" tall. When placed together both pieces are a little more than 33" wide. All of the rectangular panels are precision cut stainless steel. Stainless steel round-bar is used as the framework on the back of this sculpture as well as part of the design on the front of the piece. While only about 1" of the round bar is visible, the bars actually extend the entire length of the back sides of the piece.

Alternating black, off white, and blue panels are used. The paint on this piece has a textured finish, like sand. This piece is designed to hang on a wall and comes ready to hang. All you need is a hammer. I have also built this piece in gloss black and metallic red.

More 16" x 16" pieces can be added to increase the width of this design or to change the configuration of this piece. The largest that each individual piece can be built is 24" x 24". I set up a page that shows how I measure this design: How Pieces Are Measured . To see a variation of this sculpture with four panels, please see design: 54L